Owners manual

Page 8 of 9 405-0159 Rev E 9/14/11
22. Insert 3/8-16 x 1 1/2” hex bolt with 3/8” lock washer
into the lower back hole on the baseplate. Fasten
to a 3/8” nut plate inserted through an existing hole
underneath in the frame. Do this on both sides.
Be sure to use Loctite on the bolts.
23

25. Attach the breakaway bracket to the bottom of the
bumper between two fascia ribs with two 10-16 x
1” self drilling screws. Attach the breakaway to the
bracket with 1/4-20 x 3/4” bolt and 1/4-20 hex nut.
25

24. Attach the permanent baseplate safety cables
to the provided convenience link on the front of
baseplate (gray arrow). The photo above shows
the recommended installation of the cables to lower
cross member of vehicle (white arrow). Additional
options may interfere with suggested mounting;
in this case secure the cables to a solid piece of
the frame as described in the instructions included
with the permanent baseplate safety cables. Be
sure the safety cables do not rub against any
hoses or moving parts. Do this to both sides of the
vehicle.
24


26. Location for the 4 or 6 pin electrical coupler on the
fascia's lower air dam just below license plate.
26
22
23. On the passenger side, drill a 1/4” hole below the
big hole and pop the clip back in. Be sure it is
low enough so that the line misses the baseplate.
Reattach the horn bracket on the driver’s side.

2011-2013 Chevy Cruze LTZ
Includes Foglights
(No Eco and RS)
Installation Instructions
BX1695