Owners manual

BX1683

2009-12 Chevy Traverse

Installation Instructions

405-0049 Rev. D Page 7 of 8 11/04/11

13. Place six (6) 1/4” at washers on each bolt behind the windshield uid reservoir to move it out. Reattach the reservoir

and reconnect all the electrical and uid lines. Also reinstall horns one (1) on each side with the existing bolts (gray

arrow).

13B

15. Attach the permanent baseplate safety cables to the

provided convenience link on the baseplate (see grey

arrow). The photo above shows the recommended

installation of the cables to frame of vehicle (see white

arrow). Additional options may interfere with suggested

mounting; in this case secure the cables to a solid

piece of the frame as described in the instructions

included with the permanent baseplate safety cables.

Be sure the safety cables do not rub against any

hoses or moving parts. Do this to both sides of the

vehicle.

14. On the driver’s side, use a 1/2” drill bit to drill a hole in

the plastic. Then snap the temperature control in.



16. Hold fascia as close to its original position as possible

and trim affected areas so receiver for attachment tab

comes through lower grill. Reinstall fascia, push pins

and bolts.

4”

13A

