Owners manual

3. On the driver side only, underneath the plastic covering use a 8MM socket to remove one bolt in the corner.
Set the bolt aside to be reinstalled later.
4. Remove the four push pins from under the center front of the fascia. Set fascia and push pins aside carefully
for later reinstallation.
3
4






5. Use a 13MM socket to remove one bolt from the horn bracket and unplug. Set the horn aside to be reinstalled
later.
6. Using a T15 Torx, remove the two screws on the front of the headlight. Do this to both sides. On the
passenger side, remove the additional screw (gray arrow) from the air vent. Set aside for later reinstallation.
5


6

Page 4 of 8 405-0160 Rev E 08/24/12
2011-2013 Buick Regal CXL
(No Turbo)
Installation Instructions
BX1516

8
7



7. On the passenger side, remove the push pin from the air vent. Set aside bolts for later reinstallation.
8. Remove the clip holding the sensor to the top of the bumper (gray arrow). Using a 13MM socket, remove two
bolts from each side of the bumper. Do this to both sides. Pull the bumper forward and set it aside until later
reinstallation.