Owners manual

Page 6 of 7 405-0048 Rev. B 6/21/10
12
12
Ô
Ô
Ô
Ô
13
13
Ô
Ô
Ô
Ô
12. Using the baseplate as a template, drill two
holes on the side. Do this on both sides using
a 13/32” drill bit.
13. Into the holes drilled in the side also insert 3/8-
16 x 1 1/4” bolts with Loctite, 3/8” lock washers
and 3/8” nut plates. Do this on both sides.
15.Cover the 1 1/4” hole used to install the nut
plates with tape and paint black. Do this on
both sides.
15
15
Ô
Ô
16. The photo above shows recommended
installation of the cables to frame of vehicle.
If vehicle has additional options (not shown
above) which interfere with mounting
permanent baseplate safety cables, secure
the cables to a solid piece of the vehicle frame
as described in instructions included with the
permanent baseplate safety cables.
16
16
Ô
Ô
17. Reconnect the temperature sensor. Hold the
fascia up to its original location. Mark and
trim the fascia just on the outside edges of
the receiver tube and convenience links. Do
this to both sides of the vehicle. Reinstall the
grille.
17
17
Ô
Ô
Ô
Ô
14.Using the 13MM socket, remove top hex nut
from bumper extension and install item 13
between frame end and hex nut.
14
14
Ô
Ô
BX1306
2009 BMW Mini Cooper
(Manual Transmission Only) (Incl. Convertible) (No S or Clubman)
Installation Instructions