Owners manual

2006-10 Jeep Commander

Installation Instructions

BX1125

Install the tow bar and safety cables according

to their instructions. When demonstrating this to

the customer, be sure to include all of the Blue Ox

packaging and contents.

DO NOT substitute other devices if the tow bar

pins and clips are misplaced.

Be sure that ALL electrical connections

are plugged in properly and functioning

BEFORE Installing the fascia.

DEALER or INSTALLER:

Be certain the user receives the

instruction sheets for their products.

13. Reinstall frame rail cups, fascia, and grille to

their original positions. Be sure to install all rivets

pushpins and bolts.

12. Install the 3/8-16 x 1 1/4” hex bolts with 3/8” lock

washers into the drilled holes. Insert 3/8-16 nut

plates into the frame rail opening and align with the

bolts. Tighten all bolts. Do this to both sides of the

vehicle.

BE SURE TO USE LOCTITE

RED ON ALL BOLTS

BEFORE TIGHTENING. TIGHTEN ALL BOLTS

ACCORDING TO THE TORQUE CHART ON THE

FRONT PAGE OF THESE INSTRUCTIONS OR ON

PAGE 3 OF THE BASEPLATE TOWING GENERAL

INSTRUCTIONS.

Page 6 of 7 292-2795 Rev. G 9/27/10

11. Using the baseplate as a template, drill two holes

into the frame rail, between the radiator and the

metal bumper, with the 13/32” drill bit. Do this to

both sides of the vehicle.

When using power drills be aware of the

dangers of torque and drill bit length.