Owners manual

Vehicle Weight:
Vehicles weighing near or over 5000 pounds
(Indicated by Model note #11 on Steven’s sheet
he gives you). See below.
The weight of this vehicle is near the Class
III, 5,000 lbs. rating limitations. Some models,
depending on options, may well exceed this 5,000
lb rating. Be sure to confi rm the weight of your
individual vehicle before towing. As of 1999 the
Aventa IITM is now rated 10,000 lbs. and either
the Aventa IITM or the AlexusTM tow bar must be
used for these applications.
Tow Bar Adapters are NOT to be used with
vehicle’s weighing over 5,000 lbs.
Instructions:
The grille, front fascia, tow hooks and frame
rail cups are removed for the baseplate
installation. Drilling is required. The tow hooks
will be removed and will NOT be reinstalled.
The dimensional variations between otherwise
identical vehicles can be considerable.
While the baseplate was designed for easy
installation, it may be necessary to tailor the
baseplate slightly to compensate for auto
manufacturer’s tolerances. These minor
adjustments may include fi ling a hole slightly,
bending electrical rods or bending end plates.
The BX8869 Bulb and Socket Wiring Kit is
recommended for this vehicle.
2006-10 Jeep Commander
Installation Instructions
BX1125
2. Pull up on the black plastic on the top of the fascia
to release. Lift grille straight up to remove. Set grille
aside to be reinstalled later.
2
2
1. Remove six pushpins from the top of the fascia.
Set pushpins aside to be reinstalled later. The
driver’s side is shown.
1
1
Ô
Ô
Ô
Ô
Ô
Ô
Page 3 of 7 292-2795 Rev. G 9/27/10
Possible Location of the BX8869
Possible Location of the BX8869
Bulb & Socket Wiring Kit.
Bulb & Socket Wiring Kit.
Ô
Ô
Installation Instructions:
Handling of some cosmetic parts
when installing this product may
require the use of protective covers,
rags, specialty tools, etc. to prevent
damage.