Owners manual

21. Tighten the bolts on the lower portion of the

baseplate and all installed bolts in the top of the

frame. Do this to both sides of the vehicle.

Page 8 of 10 292-2805 Rev. D 7/23/09

20. Slide bumper between frame and baseplate to

align with existing mount locations. Insert two 8MM-

1.25 x 30MM hex bolts with 5/16” lock washers and

5/16” ﬂ at washers and tighten. Tighten the bolt near

the back of the baseplate, as indicated by the white

arrow in the photo above. Do this to both sides of

the vehicle.

2004-06 Acura MDX

Installation Instructions

BX1015

22. Align the nut plate with the drilled hole on the back

side of the radiator support and tighten the 3/8-

16 hex bolt and lock washer, as indicated by the

white arrow in the photo. Do this to both sides of

the vehicle. Using the 10MM socket, remove the

metric bolt from the air bafﬂ e, as indicated by the

grey arrow in the photo, and pull the air bafﬂ e down

away from the frame.

23. Place the backing plate on the bottom side of the

frame webbing to align with drilled holes, insert

the 3/8-16 x 1 1/2” hex bolts and 3/8” ﬂ at washers

into this hole, tighten the 3/8-16 hex nuts and 3/8”

lock washers. Reinstall the air bafﬂ e to its original

position.