Owners manual

Page 6 of 10 292-2805 Rev. D 7/23/09

13. Using a 10MM socket, remove a metric bolt from

either end of the headlight assemblies bracket. Set

the bracket aside to be reinstalled later.

14. Using a 10MM socket, remove three metric bolts

from the lower portion of the headlight assemblies

bracket. One is located under the headlight, on

the outermost edge of bracket. Two are located

closer to the mid point of bracket that is secured

to the radiator support. Do this to both sides of the

vehicle.

BE SURE TO USE LOCTITE

RED ON ALL BOLTS

BEFORE TIGHTENING. TIGHTEN ALL BOLTS

ACCORDING TO THE TORQUE CHART ON THE FRONT

PAGE OF THESE INSTRUCTIONS OR ON PAGE 3 OF

THE BASEPLATE TOWING GENERAL INSTRUCTIONS.

15. Using a 10MM socket. Pull the headlight

assemblies forward to remove. Disconnect

electrical connections. Set bolts and headlight

assemblies aside to reinstall later.

2004-06 Acura MDX

Installation Instructions

BX1015

12. On the lower section of the radiator support, use

a 10MM socket to remove the metric bolt of the

coolant tubing bracket. Do this to both sides of the

vehicle. Swivel the coolant line out of the way to

clear the area for baseplate installation.