Owners manual

Page 4 of 10 292-2805 Rev. D 7/23/09

4. Just forward of the front tire, on the outermost

bottom edge of fascia, remove two metric bolts

using a 10MM socket, as indicated by the white

arrow in the photo above. Do this to both sides of

the vehicle. Set bolts aside to reinstall later.

7. Behind the bumper, remove the temperature

sensor from its clip. Also remove two pushpin

connectors for the coax cable that are secured

behind the bumper. Set temperature sensor and

coax cable out of the way to be reinstalled later.

5. Remove three pushpins that run horizontally along

the bottom of fascia, where the belly pan and fascia

meet. Set bolts aside to be reinstalled later.

6. Start fascia removal by pulling down on the fascia

where it meets the fender, just forward of the front

tire. While still on the side of the vehicle, pull fascia

slightly forward – releasing it from two clips. Do

the steps above to both sides of the vehicle. From

the front of the vehicle, pull fascia forward enough

to disconnect the fog lights. Then, continue pulling

fascia forward to remove. Carefully set fascia aside

to reinstall later.

2004-06 Acura MDX

Installation Instructions

BX1015