Instructions / Assembly

Step 1
Place the legs (B) and support bar (C) on a soft,
non-abrasive surface such as cardboard or a blanket.
Step 2
See Figure 1. Use the wrench (EE) to attach the legs (B) to
the support bar (C) using 4 M6x15 bolts (AA) and M6
washers (CC).
Step 3
See Figure 2. Use the wrench (EE) to attach the table top
(A) to the finished frame using 8 M6x35 bolts (BB) and M6
washers (CC).
Step 4
Fully tighten all bolts and apply the bolt head caps (DD) on
to each bolt.
Eureka!
Your side table is ready to hold mimosas,
cups of tea, pastries or whatever floats your boat.
Assembly Instructions
Take a deep breath. We promise it’s pretty simple.
Note: There are two types of hex bolts. Make sure you’re using the type
specified in each step. Do not fully tighten the bolts until you’ve completed
the assembly and checked to see if the alignment is correct.
Parts
Part NameItem
B
A
C
Part Picture Qty
1
4
Table Top
Support Bar
Table Leg
1
Hardware Kit
Part Name Part Picture Qty
Bolt
M6x15
4
Wrench
Bolt Head Cap
1
M6 Washer 12
Bolt
M6x35
8
12
Item
AA
CC
DD
EE
BB
B
B
C
AA
CC
CC
A
BB
DD
Figure 1
Figure 2