Instructions / Assembly

Assembly Instructions

Take a deep Breath. we promise it’s pretty simple.

Note: There are two types of hex bolts. Make sure you’re

using the type speciﬁed in each step. Do not fully tighten

the bolts until you’ve completed the assembly and

checked to see if the alignment is correct.

Step 1

Place legs (B) and support bar (C) on a soft,

non-abrasive surface such as cardboard or a blanket.

Step 2

See Figure 1. Use the wrench (EE) to attach the legs

(B) to the support bar (C) using 8 M6x15 bolts (AA)

and M6 washers (CC).

Figure 1