Instructions / Assembly

Assembly Instructions

Take a deep Breath. we promise it’s pretty simple.

Note: There are two types of hex bolts. Make sure you’re

using the type speciﬁed in each step. Do not fully tighten

the bolts until you’ve completed the assembly and

checked to see if the alignment is correct.

Step 1

Place the left legs (B), right legs (C) and support bar

(D) on a soft, non-abrasive surface such as

cardboard or a blanket.

Step 2

See Figure 1. Make sure that the placement of all

four legs (B and C) match the illustration below

before proceeding.

Step 3

See Figure 2. Use the wrench (EE) to attach the legs

(B and C) to the support bar (D) using 4 M6x15 bolts

(AA) and M6 washers (CC).

Outside edges of all four legs square

Figure 1