User guide

36
37
Cover Removal
Remove the infant body pillow.1
Loosen the harness by lifting the harness 2
adjuster lever while pulling both shoulder
straps forward as far as possible.
Unhook the shoulder straps from the harness 3
yoke on the rear of the child seat (Fig. A).
Pull the upper harness straps through the 4
head restraint and cover to the front of the child seat.
Remove the buckle and belly pad. See page 38.5
Remove the head restraint portion of the cover. Be careful not 6
to damage the energy-absorbing foam.
Remove the energy-absorbing foam from the head restraint 7
and set aside.
Gently remove the upper portion of the cover by pulling it 8
around the head restraint to the front.
Pull the lower harness straps, buckle tongues, HUGS9
™
chest
pads, and chest clip through the lower slots in cover.
Remove the entire cover from the child seat.10
Refitting the Cover
To refit the cover, reverse the above directions. Make sure that
the shoulder straps are not twisted, and are threaded properly
through the chest clips, cover, foam, and shell.
A
Care and Maintenance Care and Maintenance
Cleaning the Cover
HAND WASH using cold water and mild soap.•
LINE or LIE-FLAT DRY to prevent the cover from shrinking.•
DO NOT• bleach, machine wash, machine dry or iron.
Cleaning the Shell
SPONGE CLEAN using warm water and mild soap.•
TOWEL DRY•
DO NOT• use solvents or abrasive cleaners.
Cleaning the Harness
SPONGE CLEAN using warm water and mild soap.•
TOWEL DRY•
DO NOT• bleach, machine wash, machine dry or disassemble
the harness.
Cleaning the Harness Adjuster
Periodically check the adjuster area to be sure it is clean and
free of food, drink or other debris. If debris is present, it must be
removed to prevent interference with the adjuster mechanism.
BRUSH AWAY LOOSE DEBRIS using a soft-bristled brush.•
SPONGE CLEAN using warm water and a mild soap.•
TOWEL DRY•
DO NOT• use solvents, abrasive cleaners or disassemble the
harness.
WARNING! Do not take apart the harness. Never remove
the buckle tongues from the harness. They cannot be reattached
after removal. If reassembled incorrectly, the child seat may not
perform as intended.