User guide

30
31
Storing the LATCH Connectors
When the LATCH connector is not in use, lift the
cover to access the LATCH storage slots (Fig.
A). Fold the LATCH adjuster and the connector,
then slide each set into the adjacent slot.
NOTE: Child seats are shipped from Britax with
the LATCH connectors in the storage slots.
Recline Adjustment
Pull the recline handle (Fig. B) then slide the
child seat shell into the desired position. Release
the recline handle, then verify the child seat has
locked into position.
Chest Clip
Fastening the Chest Clip
Fasten the chest clip by pushing the two
halves together until a positive click is heard
(Fig. D).
Releasing the Chest Clip
Squeeze the middle tabs together (Fig. E).1
Pull the two pieces apart.2
Adjusting the Chest Clip
Slide the chest clip up or down (Fig. F) 1
on the harness so it is positioned at the
middle of the child’s chest, level with the
child’s armpits.
Slide the HUGS2
™
chest pads and comfort
pads to a comfortable location for the
child.
HUGS™ Chest Pads
b
A
Child Seat Functions Child Seat Functions
NOTE: It will be necessary to loosen the tether, vehicle seat belt,
and/or LATCH strap before adjusting the recline position. The
tether, vehicle seat belt, and/or LATCH strap must be properly re-
tightened after adjusting the recline position.
Infant Body Pillow
The Infant Body Pillow is designed to provide better fit and comfort
for infants using this child seat. For additional side support, fold the
side flaps inward (Fig. C).
NOTE: Remove the Infant Body Pillow after child can sit comfortably
in the child seat without additional support.
WARNING! HUGS
™
chest pads must
be installed for forward-facing use. Removal
of HUGS is optional only for rear-facing use.
WARNING!
This child seat must be in the recline position •
when installed rear-facing.
Child seat must be in full upright position •
when installed forward-facing with children
who weigh more than 15 kg (33 lbs).
c
E
F
D