Replacement Part List

MAINTENANCE AND
SERVICING
ACCESSORY STORAGE
AND HANDLING
CLEANING, MAINTENANCE,
AND LUBRICATION
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and
unplug the tool from its electrical outlet
before performing any procedure in this
section.
TO PREVENT SERIOUS INJURY FROM
TOOL FAILURE:
Do not use damaged equipment. If
abnormal noise or vibration occurs, have
the problem corrected before further use.
Procedures not specifically explained
in this manual must be performed only
by a qualified technician.
c. Pull down on the Handle to bring
the Grinding Wheel into the Gullet,
then make adjustments:
• Turn the Chain Stop Adjustment
Knob until the Grinding Wheel
just grazes the cutting edge.
Tighten the Chain Stop Lock Nut.
• Turn the Depth Adjustment Knob
until the Grinding Wheel is just
above the bottom of the Gullet.
Tighten the Depth Adjustment
Lock Nut.
7. Clean and oil the chain before
reinstalling it on the chain saw.
8. To prevent accidents, turn off
the tool and unplug the tool from
its electrical outlet after use.
Clean, then store the tool indoors
out of children’s reach.
b. Turn the Chain Roller until the first
left-hand cutter is in position. Then,
engage the Chain Stop.
c. Follow instructions for 5.
Sharpening the right-hand cutters:
beginning at c. and ending at i.
d. Plug in the Sharpener and turn it on.
e. Allow the Sharpener to come up to
full speed.
f. Squeeze the Vise Handle and pull
down on the Handle until the
Grinding Wheel makes contact
with and sharpens the cutting edge.
1. BEFORE EACH USE, inspect the
general condition of the tool.
Check for:
• loose hardware,
• misalignment or binding of moving
parts,
• cracked or broken parts,
• damaged electrical wiring, and any
other condition that may affect its
safe operation.
2. AFTER USE, wipe external surfaces
of the tool with clean cloth.
3. Periodically, wear ANSI-approved
safety goggles and NIOSH-approved
breathing protection and blow dust
and grit out of the motor vents using
dry compressed air.
4. Replace the Grinding Wheel once
it has worn down to a diamter of 3".
5. WARNING! If the supply cord of this
power tool is damaged, it must be
replaced only by a qualified service
technician.
1. Handle accessories carefully to
prevent dropping or bumping.
Do not use wheels that have
been dropped or bumped.
2. Store accessories in shelves,
racks, boxes, or drawers. Keep
storage area dry and above freezing.
Any grinding or cut-off wheels exposed
to humidity or freezing temperatures
must not be used.
CAUTION! Turn the Sharpener off
before moving chain.
g. Turn the Chain Roller until the
next cutter is in position. Turn the
Sharpener on, then sharpen that
cutter.
h. Continue until all of the cutters
have been sharpened.
i.
Turn off the Sharpener, then unplug it.
6. Sharpening the left-hand cutters:
Note: Leave the chain in the Vise.
a. Loosen the Angle Adjustment Knob,
align the Angle Arrow to the correct
angle to the right of 0 on the Miter
Gauge, then tighten the Angle
Adjustment Knob.
[e-mail]
6
1-800-348-5004
Cutting
Edge
Gullet
Figure F: Right-hand Cutter
Gullet
Cutting
Edge
Figure G: Left-hand Cutter