Replacement Part List

SETUP - BEFORE USE:
MOUNTING
5. Grip workpiece as lightly as
possible (while still keeping safe
control of it). Let the tool do the
work.
6. To reduce vibration, maintain the
tool as explained in this manual.
If any abnormal vibration occurs,
stop use immediately.
Note: For additional information
regarding the parts listed in the
following pages, refer to the
Assembly Diagram near the
end of this manual.
Note: The Sharpener must be
mounted on a horizontal surface.
1. Position the Sharpener on the
mounting surface so that the
mounting stop butts up against
the vertical edge of the surface.
2. Using the Base as a template,
mark locations of mounting holes.
3. Drill pilot holes appropriate for the
proper hardware (sold separately),
described under Specifications on
page 1, at the marked locations.
4. Align mounting holes with pilot
holes, then secure the Base with
the hardware.
ATTACHING THE VISE
FUNCTIONS
1. Slide the bolt on the bottom of the
Vise assembly through the hole on
the Base. Secure from underneath
with the Angle Adjustment Knob.
2. Remove the Clamp Lock Nut from
the Vise Cable
3. Push the Vise Cable through the
hole in the Clamp Plate and secure
with Clamp Lock Nut.
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION: Turn the
Power Switch of the tool off and unplug
the tool from its electrical outlet before
performing any procedure in this section.
Read the ENTIRE IMPORTANT SAFETY
INFORMATION section at the beginning
of this manual including all text under
subheadings therein before set up or
use of this product.
[e-mail]
4
1-800-348-5004
Mounting
Holes
Mounting
Stop
Mounting
Surface
Figure A
Vise
Assembly
Bolt
Angle
Adjustment
Knob
Figure B
Clamp
Lock Nut
Vise
Cable
Clamp
Plate
Figure C
Handle
Vise
Handle
Depth
Adjustment
Knob
Depth
Adjustment
Lock Nut
Chain Stop
Adjustment
Knob
Vise
Clamp
Plate
Clamp
Lock Nut
Chain Roller
Knob
Angle
Adjustment
Knob
Chain Roller
Knob
Chain
Stop
Depth
Adjustment
Stop
Depth
Adjustment
Plate
Power
Switch
Vise
Cable
Chain Stop
Lock Nut