Use and Care Manual

8
[e-mail]
2. Hold the product firmly so that it
sits with a gap between the
product and your right side.
3. Stand upright, do not lean
forward and pay attention to
posture. Keep both feet apart to
help retain your balance.
4. Never hold the cutting head
higher than your hip; the higher
you hold the cutting head, the
greater the risk for objects being
thrown.
5. Carefully plunge the blade from
above when cutting long
undergrowth.
6. Move the cutting head towards
the base of young trees or thicker
vegetation.
TRIMMING
1. Use the trimmer head (37) to cut
smaller types of weed, lawn grass,
or similar soft vegetation.
2. Hold the product firmly so that it
sits with a gap between the
product and your right side.
3. Stand upright. Do not lean
forward and pay attention to
posture. Keep both feet apart to
help retain your balance.
4. Hold the trimmer head just
above the ground at an angle of
approximately 30°
5. Move the product with a slow
and regular arc from the left to
right before moving back to the
starting position before trimming
the next area.
6. Ensure the cutting head remains
clean and free from off-cuts that
may cause it to jam. Check
regularly. Stop the engine, switch
the ignition switch (29) to STOP
and remove the spark plug
connector (2) before checking.
7. Trim longer grass in stages.
DO NOT cut long grass in one
cut (Fig. 23).
8. Feed the trimming line if it is
worn-out or ripped by tapping
the bumper (38) on stable
ground.
TIPS
1. For best results, do not cut
wet grass because it tends to
stick to the cutting heads and
guard, prevents proper
discharge of grass trimmings,
and could cause you to slip and
fall.
2. Pay special attention when
performing the work close to
trees and bushes. The cutting
heads could damage sensitive
bark, and damage fence posts
(Fig. 24).
STOPPING
1. Release the throttle interlock
(30) and throttle control (27) and
let the product run at its idle
speed for 10-15 seconds (Fig.
25).
2. Set the ignition switch (29) to
position “O”.
WARNING: The cutting heads
will continue to rotate for
some time after the engine
has been switched off. Wait
until the head has come to a
complete stop before placing
the product on the ground.
AFTER USE
1. Switch the product OFF,
disconnect the spark plug
connector, and let it cool down.
2. Check, clean, and store the
product as described.
FIG. 23
FIG. 24
FIG. 25
FIG. 26
FIG. 28
FIG. 27