Appliance Trim Kit User Manual

Volume 9: Managing the Blue Coat SG Appliance
34
2. In the Restart field, select either Software only or Hardware and software.
3. If you select the
Hardware and software option, select a system from the System to run
drop-down list.
The default system is pre-selected.
4. Click
Apply.
5. Click
Restart now.
6. Click
OK to confirm and restart the SG appliance.
Related CLI Syntax to Configure the Hardware/Software Restart Settings
SGOS#(config) restart mode {hardware | software}
SGOS# restart abrupt
SGOS# restart regular
SGOS# restart upgrade
Restoring System Defaults
SGOS allows you to restore some or all of the system defaults. Use these commands with
caution. The
restore-defaults command deletes most, but not all, system defaults:
❐ The restore-defaults command with the factory-defaults option reinitializes
the SG appliance to the original settings it had when it was shipped from the factory.
❐ The restore-defaults command with the keep-console option allows you to
restore default settings without losing all IP addresses on the system.
Restore-Defaults
Settings that are deleted when you use the restore-defaults command include:
❐ All IP addresses (these must be restored before you can access the Management
Console again).
❐ DNS server addresses (these must be restored through the CLI before you can access
the Management Console again).
❐ Installable lists.
❐ All customized configurations.