User manual

PE3M Small Form Factor PC Upgrading the System Hardware
Page 27
Ensure that the CD/DVD IDE cable will not foul the PCI card.
Replace the AGP/PCI Riser card sub-chassis. Take care lining up the two riser cards into their sockets, and
apply pressure evenly to fully seat the cards in the motherboard. This may require a little practise if both
expansion cards are fitted.
Secure the sub-chassis using the countersunk-head M3 fixing screws removed earlier.
Replace the top cover.
Follow the instructions provided with the expansion board(s) to install any software drivers and application
software. Note that the installation may vary depending upon the operating system in use.