User manual

PE2M Small Form Factor PC Installation - Mounting
Page 18
NEC 42PD2 Display
This procedure applies only to the 42PD2 with models PE2M-DV, PE2M-CD, PE2M-FD.
Fit the two mounting brackets as shown in the diagram using four M4 x 6mm fixing screws. Note the
orientation of the brackets to avoid any restriction of the fans.
Due to the restriction caused by the carrying handle on the 42PD2 display, it is necessary to fit the (right-
angle) AC power connector to the display before fitting the PE2M. DO NOT CONNECT THE AC POWER
TO THE UNIT AT THIS STAGE.
Assemble the PE2M to the display using four M3 x 6mm screws.