User manual

PE2M Small Form Factor PC Installation - Mounting
Page 17
Assemble the PE2M to the display using four M3 x 6mm screws.
Due to the restriction caused by the carrying handle on the 42PD2 display, it is necessary to fit the (right-
angle) AC power connector to the display before fitting the PE2M. DO NOT CONNECT THE AC POWER
TO THE UNIT AT THIS STAGE. This restriction does not apply to the 42PD3 display.
Fit the right-angle AC power connector to the PC. DO NOT CONNECT THE AC POWER AT THIS STAGE.
Fit the graphics output cable between the graphics output connector on the PC and the input connector of the
display.
Fit any peripheral cables as required.
Connect the AC power lead to a suitably fused source and an earth (ground) point.