Specifications

QUICK REFERENCE CATALOG Chassis 19-7
19
C
H
A
S
S
I
S
if you can use one of these...
you’ll nd the heaters that need replacing before the
weather turns cold.
To check any engine pre-heater without having to
plug the unit in, use a continuity tester in accordance
with the accompanying diagram.
Using the power blades and the ground post,
check ALL 3 terminals to determine if the pre-
heater is working.
ENGINE BLADE IMMERSION HEATERS, CONT’D
REPLACEMENT PARTS AND ACCES-
SORIES
WATTS
P/N
120 VOLTS
P/N
240 VOLTS
NOTES
6-FOOT CORDS
Standard cord IM6-1IN IM6-2IN
For recessed plug 11PR72T 21PR72T 4
FLIP COVERS AND PLUG HOUSINGS
Flip cover (black) FC-KH FC-KH
Plug housing (receptacle) A2223-PH A2223-PH
THERMOSTAT CONTROL CORDS
ON at 80, OFF at 100 A2822-0M A2822-0P
ON at 100, OFF at 120 A2822-0B A2822-0H
HEAT SHIELD
Use when manifold or turbo heat
comes close to cord
HS1 HS1
NOTES:
1. Use heat shield HS1 on these applications.
2. Replacement cord is not available.
3. Use a tank-style heater—i.e., TPS101t10-000 for these applications.
4. Must use the ip cover and plug receptacle with this cord design.
5. Installs in a threaded port in the oil cooler housing.
6. Installs in the second from the front freeze plug opening on right side of the block.
Terminal to
Terminal
If the Light
Lights
If the Light
Stay Out
1 to 2 Bad Good
1 to 3 Bad Good
2 to 3 Good Bad