User's Manual

P25 Installation Guide
http://www.bluebamboo.com
9
Figure 7: Remove battery
2. Remove the battery pack.
2.3.2 Battery and charge
1．Insert the DC plug of power adaptor into the power jack of printer;
2．Insert the AC plug of power adaptor into AC power supply;
3．Start battery charge, and red LED light continuously;
4．Finish charging, the red LED turn off.
Figure 8: Battery recharge
Warning:
Notice:
1. If the red LED turns on for a short time and then turn off quickly when starting the battery
charge procedure, there are two probable reason: first is you have completed battery charging,
no need to charge again, second is this battery doesn’t work, please change it.
2. The red LED should turn on during charging and turn off after charging, please care for its
status is right or not.