User guide

P25 End User Guide

Notes:

a. When installing or removing the battery pack, the printer should be turned off.

b. The battery pack should be removed if the printer is not going to be used for a long time.

4.3.2 Battery and charge

The printer power is supplied by a lithium ion battery with a 100VAC-240VAC power adapter for the battery

charging. The battery life time is 500 charging cycles. In a full charge, the printer can last no less than 100

hours in standby mode and print more than 200 pieces of 100 mm receipts in working mode.

The battery pack has the following specifications:

− Rate Voltage: 7.4V

− Peak circuit: 5A

The AC charging adapter has the following specifications:

− Construction: The adapter has a power cord to the outlet and has a country specific for the plug and a

DC power cord to the printer

− Input voltage: AC 100–240V, 50/60HZ

− Output: 9.0V DC 1.0A

The power adapter is connected to the left side of the printer.

a. Insert the DC plug of power adapter into the power jack of printer;

b. Insert the AC plug of power adapter into AC power supply; the red LED will flash continuously when the

battery is being recharged.

c. When charging is complete, the red LED will turn off.

Figure 9: Battery recharge

Warning:

Notice:

If the red LED turns on for a short time and then turns off quickly when the battery starts charging, there are

two possible reasons: Either the battery is completely charged, and there is no need to charge again, or this

battery doesn’t work; please change it.