Specifications

P25 Development Guide
www.bluebamboo.com
21
5
d indicates the bit-image data. Set a corresponding bit to 1 to print a dot or to 0 to
not print a dot.
6
If the width of the printing area set by GS L is less than the width required by the
data sent with the ESC * command, the following will be performed on the line in
question (but the printing cannot exceed the maximum printable area).The width of
the printing area is extended to the right to accommodate the amount of data. If step
does not provide sufficient width for the data, the left margin is reduced to
accommodate the data.
7 After printing a bit image, the printer returns to normal data processing mode.
8
This command is not affected by print modes (emphasized, double strike, underline,
character size or white/black reverse printing), except upside-down printing mode.
9 The relationship between the image data and the dots to be printed is as follows:
10 [d1…dk] is the data.
11 Deprecated, better use horizon mode.