Specifications

P25 Development Guide
www.bluebamboo.com
10
2.2 Line Space Commands
The P25 printer supports the following commands for setting line space. These commands can
only be used for specifying line space, not actually feeding paper. The line space set through
these commands affects the results of LF and ESC d and paper feeding by using FEED.
Command
ESC 2
Select default line space
ESC 3
Set line space
ESC 2
[Name] Select default line space
[Format] ASCII ESC 2
HEX 1B 32
Decimal 27 50
[Description] Select 1/7 inch line (approx. 3.75mm) space
[Reference]
ESC 3
ESC 3
[Name] Set line space
[Format] ASCII ESC
HEX 1B 33 n
Decimal 27 51 n
[Range] 0 ≤ n ≤ 255
[Description] Set the line space to [n x vertical or horizontal motion until] inches.
[Note]
1) The horizontal and vertical motion unit is specified by GS P. Changing
the horizontal or vertical motion unit does not affect the current line
space.
2) The GS P command can change the horizontal (and vertical) motion unit.
However, the value set by this command cannot be less than the
minimum vertical movement amount set by GS P, and it must be in even
units of the minimum vertical movement amount.
[Reference]
ESC 2, GS P