Installation guide

Charge Printer
1.Insert the DC plug of power adapter into
the power jack of printer.
2.Insert the AC plug of power adapter into
AC outlet.
3.When charging the LED will be red, when
the battery is fully charged, the LED will
turn off.
Note: Please make sure the battery
contact guard is removed before
charging for the first time. See Install
Battery.
Insert plug here
MSR (P25-M & P25i-M only)
Remove Rugged Case
1.Hold the printer with rugged case by the
sides.
2.Pop two fingers under the printer, then
pull the printer out of the case.
Note: Please don't peel off the rugged case from
the printer.
For warranty period, repair and service
issues, please contact your distributor:
Install Battery
The battery pack is located at the bottom
of the printer. To install it please follow
these steps:
1.Remove the rugged case.
2.Remove the battery pack as shown
below.
3.Remove the battery contact guard
from battery.
4. Reinstall battery and rubber case.
Optional Accessories
Contact your distributor for more information.
Carrying Case
Car Charger
WARNING:
•Do not disassemble the Printer, battery
or AC adapter. Only qualified technicians
may service the device.
•Do not use batteries, AC adapters or
Printer near water.
Caution
Load Paper
1.Open the lid.
2.Insert the shaft into the paper roll.
3.Install paper roll with paper pointing up.
4.Pull out a small amount of paper, close lid.
Swipe slot
1. Ensure the magnetic stripe faces away
from the printer.
2. The magnetic stripe reader (MSR) can
read tracks 1/2/3 in both directions
(bidirectional).
3. MSR data can be transmitted via Serial,
USB, or Bluetooth.
Swipe card
in either direction