Installation guide

Battery
Packing List
Printer Paper
ShaftUSB or Serial
Cable
Power Adapter
Version 4.9
P25 Printer
Quick Installation Guide
P25 / P25-M / P25i / P25i-M
BuckleRugged Case
Front
Feed button
USB or
Serial port
LED indicator
Mode button
Power jack
MSR
(P25-M and
P25i-M only)
Power
button
Paper cutter
PIN code
LED Status Code
Constantly lit
Flashing
Constantly lit
Flashing
Constantly lit
Flashing
intermittently
with Blue LED
Off
Bluetooth module
available
Data transaction
via Bluetooth
Power on, normal
status
Data transaction
via USB
Charging
An error has
occurred (see
Error Code)
Charging finished
Back
Battery
release
Buckle screw
Battery
contact
guard
Remove
before use
Battery
Contact your distributor for replacement parts
Cable Connection
Connect Printer to host device using
correct cable.
Insert mini-USB
or serial cable here
Cable/port
Serial
USB
Host
DB9(F)
USB Type A
Printer
mini-USB type A
mini-USB type B
LED Error Code
Error Remedy Indicator
description pattern
Out of paper Add paper
The paper
cover is open
Close the
paper cover
A transmission
error occurred
Check the
transmission
status
Print head
overheated
Wait until the
print head
cools down
Battery
voltage
is too low
Recharge
the
battery
Bluetooth
Device name and PIN
●Device name and PIN label can be
found under the paper roll
Discovery Modes (factory set)
●Always - Always discoverable
●1st Connect - Discoverable until 1st
connection is established
●Mode Key - Press Mode Key to make
discoverable for 90 seconds
Using with Apple devices
(P25i & P25i-M only)
●Press Mode Key twice to disconnect
and press twice again to receconnect
●Blue LED will flash when connecting /
disconnecting from Apple devices
●Supports iOS 4.0 and highter
To print test receipt, press mode & feed buttons
at the same time.
Front