User guide

P25 Series End User Guide
www.bluebamboo.com 20
− On your Apple device’s home screen tap Settings → General → Bluetooth.
− If your Apples device Bluetooth is not tuned on at this time, then move the Bluetooth slider to
"On".
− Your Apple device will then search and list all discoverable Bluetooth devices within range.
− Find your P25i/P25i-M printer on the displayed list and select it. The printer’s LED will flash blue
for several seconds. (The printer’s Bluetooth name can be found under the printer paper roll.)
−
Next enter the printers PIN code. The printer’s LED will turn solid blue when successfully
connected. (The printer’s Bluetooth PIN can be found under the printer paper roll.)
− The printer should now be connected and ready to use.
Subsequent Connections
− Your P25i/P25i-M printer is designed to automatically connect to the last Apple device it was
connected with. The only exception to this is if the printer’s last connection was to a non-Apple
device, then the printer’s memory will be erased. If your last connection was to a non-Apple
device or you want to connect to a different Apple device then you must follow the step as shown
in the First Connection above.
− To re-establish a connection, first make sure your Apple’s device Bluetooth is turned on.
− Power on the printer.
− The printer should now automatically connect to your Apple device. The printer’s LED will flash
blue when connecting and then turn solid blue when successfully connected.
− If printer was already powered on then simply press the MODE key twice to re-establish a
connection.
Disconnect
There are four ways to disconnect your printer from your Apple device.
− Option 1: Power off printer.
− Option 2: Press MODE key on printer twice. (Press twice again to re-establish)
− Option 3: Turn-off Bluetooth on your Apple device.
− Option 4: In the Bluetooth settings of your Apple device, select your printer and then select
“Forget this Device”. (Warning – This will remove the pairing agreement between your Apple
device and printer and you will have to follow the step as shown in the First Connection above
to re-establish pairing.)