User guide

P25 Series End User Guide
www.bluebamboo.com 14
4.3.2. Battery and Charging
Power to the printer is supplied by a polymer lithium ion battery which uses a 100 - 240VAC Power
adapter for charging. A typical battery can last for ~500 charging cycles and will run a printer for up to
100 hours in standby Mode and print more than 200 pieces of 100 mm receipts for each charge.
Battery specifications:
− Rate Voltage: 7.4V
− Output current: 1400mAH
AC Power adapter specifications:
− Power plug: The adapter has a Power cord to the outlet and has a country specific for the plug
and a DC Power cord to the printer
− Input voltage: AC 100–240V, 50/60HZ
− Output: 9.0V DC 1.0A
The Power adapter is connected to the left side of the printer.
a. Insert the DC plug of Power adapter into the Power jack of printer;
b. Insert the AC plug of Power adapter into AC Power supply; the red LED will flash continuously
when the battery is being recharged.
c. When charging is complete, the red LED will turn off.
Warning:
If the red LED turns on for a short time and then turns off quickly when the battery starts charging,
there are two possible reasons: Either the battery is completely charged, and there is no need to
charge again, or this battery doesn’t work; please change it.