User guide

6
STATUS LED MESSAGES
The meanings of the various status LED messages shown by the BluComm Adapter are
shown on the following table:
TROUBLESHOOTING
My wireless audio accessory will not pair with the Adapter.
Follow the instructions to place the BluComm Adapter into the correct pairing mode and then
activate the pairing mode on the accessory. Make sure that the BluComm Adapter and
accessory being paired are within one meter of each other.
My wireless audio accessory or worked before, but is not working now.
Make sure that the BluComm Adapter is properly connected to the two-way radio and that the
radio is turned on. Ensure that your wireless audio accessory has a fully charged battery and is
turned on. If the devices will still not work, re-pair the BluComm Adapter to the wireless
accessories.
My radio shows "Keyloader" on the LCD when I press the Talk button of the Adapter.
When your press the talk key with no wireless headset paired, the radio believes a keyloader is
attached to the radio. Disable the keyloader function in the radio's programming software or
pair a wireless accessory with the adapter.
LED INDICATION
One flash per minute
Two flashes per minute
One long flash for three seconds
No indication
MEANING
Normal operation
Audio accessory pairing mode active
Successfully paired or re-paired
Radio is turned off
Status LED