Installation & Operation Instructions

CHASE NIPPLE
SERRATED END FOR CUTTING
THROUGH CEILING TILE
ALTERNATE CHASE NIPPLE
REAR POSITION
SENSOR &
MOUNTING
BRACKET
LOCKING 3-POSITION
TILT ADJUSTMENT
PROGRAMMING
BUTTON
ADDITIONAL MOUNTING METHODS
SCREW HOLES FOR
MOUNTING TO FLAT WALL
CHANNELS FOR SLIDING
OVER MOUNTING SCREWS
SCREW HOLES FOR
MOUNTING IN CORNER
TOP INSTALLATIONMOUNTING WITH CHASE NIPPLE
RECOMMENDED
CHASE NIPPLE
LOCK NUT
MOUNTING
BRACKET
REAR INSTALLATION
CHASE NIPPLE
LOCK NUTMOUNTING BRACKET
CHASE NIPPLE & LOCK NUT INCLUDED FOR MOUNTING
TO CEILING TILE OR 1/2” KNOCKOUT IN JUNCTION BOX
TWO 1/2” TRADE SIZE
KNOCKOUTS FOR USE
WITH CHASE NIPPLE
OR DIRECT CONDUIT
CONNECTION
INSTALLATION OPTIONS
Ã The sensor runs on one CR123(A) Lithium Battery (included).
Ã Install battery prior to mounting sensor. Polarity is indicated on the battery
compartment door.
Ã If the sensor’s battery life reaches 10%, all wirelessly linked load controllers will
blink lights on/off/on upon initial occupancy as a replacement warning.
Ã Replacement batteries are available at most retailers or home centers where
batteries are sold or from SENSORWORX.
MOUNTING
BRACKET
CHASE NIPPLE
BATTERY
COMPARTMENT
BATTERY
COMPARTMENT
BATTERY
COMPARTMENT
LOCK NUT
CHASE NIPPLE
LOCK NUT
LOCKING 3-POSITION
TILT ADJUSTMENT
MOUNTING
BRACKET
LOCKING 3-POSITION
TILT ADJUSTMENT
SERRATED END
FOR CUTTING
THROUGH
CEILING TILE
SERRATED END FOR CUTTING
THROUGH CEILING TILE
BATTERY INFORMATION