Owner`s manual

FIGURE A

INSTALLATION INSTRUCTION

FOR BASE EXTENDER KIT #83334

FOR MODEL 8748

TEA BREWER

ELECTRICAL SHOCK HAZARD: Turn off the Tank Heater Switch and disconnect

power supply to Brewer before removal of any panel. Electrical shock will cause

death or serious Injury.

CAUTION:

Wait until the water in the tank has cooled down to room temperature

before Installing this Kit. Failure to comply will cause severe burns.

STEP 1: Remove the Screws from the Back Panel (ITEM 1). Remove the Back Panel. (FIG A)

STEP 2: Drain Tank.

STEP 3: Set the Brewer on It’s side and remove the Bottom Base and Legs (ITEM 2). (FIG A)

STEP 4: Locate the Base Extender (ITEM 4) and the Speed Nuts (ITEM 3) included in the Kit.

Push the Speed Nuts onto the top and bottom flanges at each hole location. (FIG B)

STEP 5: Orient the Base Extender (ITEM 4) with the seam to the rear, the Bottom Base (ITEM 5)

and the Bottom Panel (ITEM 6) included in the Kit as shown on the exploded view (FIGURE B).

Make sure all the holes line up. Mount the Extender first, then the Base and Bottom Plate with

the Screws included in the Kit.

STEP 6: Replace the Back Panel (ITEM 1).

FOLLOW THE INITIAL INSTALLATION INSTRUCTION IN THE 8746 MANUAL FOR PROPER BREWING.

Part Number 73332