Specifications

TROUBLESHOOTING SUGGESTIONS

SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY

Water won’t heat

Circuit breaker tripped, main power switch

or tank heat switch turned off

Check / reset circuit breaker.

Turn switches on.

Temperature setpoint too low Set for desired temperature

Hi-Limit safety switch tripped Allow to cool, reset hi-limit reset

Damaged internal component or wiring

Examine wiring & connectors, controller,

power board and heating element.

Repair/replace as needed

Coffee level too high or low Timer out of adjustment Adjust timer

Brew chamber overows

Too many lter papers or wrong lter paper

Use one (1) genuine Bloomeld lter per

brew

Brew chamber dispense hole plugged Thoroughly clean brew chamber

Too much coffee or too ne a grind Use correct grind and amount of coffee

Sprays water from brew head Spray gasket improperly installed

Check/reinstall gasket on INSIDE of brew

head

No brew

Spray disk plugged Clean spray disk

Damaged internal component or wiring

Check switch, timer, solenoid, Repair,

replace as needed

No brew plus no ow from hot

water faucet

Water supply OFF Turn water supply ON

Solenoid inlet strainer plugged Clean strainer

Water lter (if used) plugged Replace lter element

No ow from hot water faucet Faucet plugged Disassemble faucet, clean

Continuous ow or drip from

brew head

Damaged solenoid Replace solenoid

Faucet water level probe limed-up or has

calcium deposits. “service tank” indicator lit

Delime faucet water tank

Poor coffee quality

Keep brewer and decanters clean. Install a taste and odor lter in water supply, and

replace cartridges regularly. Use a quality coffee with a consistent roast. Use proper

grind and amount of coffee per brew.

915 2M-Z15131 Owners Manual for 8783MCD