Specifications

OPERATION

Fig. 4 Brewer Operation Diagram

START-UP

For initial start-up, or if the brewer has not been used for an

extended period of time:

• Be sure spray disk and brew gasket are properly installed in the

brew head.

• Be sure the water supply is properly connected and the water supply

valve is turned ON.

• Be sure the WATER

TANK IS FILLED

BEFORE energizing the tank heater THE WATER TANK MUST

BE FILLED. Place an empty decanter under the brew head. With

the TANK HEATER SWITCH OFF, press the START BREW

SWITCH. Run at least three full brew cycles, or until water

ows from the brew head. When water stops dripping, empty the

container.

Once the tank is full of water, press the TANK HEATER SWITCH

to ON. The heating elements will begin heating the water in the

tank. When the water has reached the proper temperature, the

“READYTO BREW” light will go glow.

IMPORTANT:

Tank must be full of

water before connecting

brewer to electrical power.

Heating elements will be

damaged if allowed to

operate without being fully

submerged in water.

Damage caused by

operating the brewer

without water in the tank

is NOT COVERED BY

WARRANTY.

913 p/n 2M-75937 Owners Manual 8718, 8738 Coffee Brewer