Specifications

SERVICING INSTRUCTIONS (continued)

REPLACE SOLENOID

Symptom: Automatic brewer will not ow water; or,

automatic brewer drips continuously from brew head.

Unplug power cord or turn circuit breaker OFF. Turn OFF and

disconnect water supply from brewer inlet tting.

A. (OLD-STYLE)

Remove hex nut holding inlet tting into back of brewer.

Remove two screws holding access door in place. Remove

access door. Remove front panel.

On faucet models, remove are connection from “tee” inlet

tting.

Push solenoid forward slightly and lift to release it from

bracket.

Disconnect wiring and remove rubber tubing from solenoid.

Remove ttings from old solenoid and transfer to new

solenoid. If necessary, replace ow control at this time.

B. (NEW-STYLE)

Unscrew water inlet tting from solenoid.

Remove two screws holding access door in place.

Remove two screws holding solenoid to door.

Remove brew water

tube from solenoid. On faucet models,

remove faucet water tube from bypass side of solenoid

by pressing the white ring portion of the tube tting tightly

against the metal portion while pulling the tube off of the

solenoid.

Disconnect wiring from solenoid.

Transfer solenoid bracket to new solenoid.

Reassemble in reverse order.

CLEAN SOLENOID SCREEN (NEW-STYLE)

Symptom: Automatic brewer will not ow water.

Unplug power cord or turn circuit breaker OFF. Turn OFF and

disconnect water supply from brewer inlet tting.

Unscrew water inlet tting from solenoid.

Using needle-nose pliers, withdraw strainer screen from solenoid.

Clean screen under faucet. A stiff bristle brush may be used if

necessary.

Reinsert screen in solenoid. Be careful to maintain correct

orientation. (The OPEN END

of the screen goes in FIRST.)

Reassemble in reverse order.

Fig. 12 Clean Strainer Screen

Fig. 11 Remove Faucet

Supply from Solenoid

913 p/n 2M-75937 Owners Manual 8718, 8738 Coffee Brewer