User Manual

TROUBLESHOOTING SUGGESTIONS
10
608 p/n 2M-76467 8740 Tea Brewer Owners Manual
SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY
Water won’t heat
Brewer unplugged or circuit breaker
tripped
Check power supply cord
Check / reset circuit breaker
Tank heater switch OFF Press switch to ON
Temperature setpoint too low Set for desired temperature
Hi-Limit safety switch tripped Allow to cool hi-limit will self-reset
Damaged internal component or
wiring
Examine wiring & connectors, controller, power
board and heating element, Repair/replace as
needed
Tea level too high or low Timer out of adjustment Adjust timer
Brew chamber overows
Too many lter papers or wrong
lter paper
Use one (1) genuine Bloomeld lter per brew
Brew chamber dispense hole
plugged
Thoroughly clean brew chamber
Too much tea leaves Use correct amount of tea
Sprays water from brew
head
Spray gasket improperly installed Check/reinstall gasket on INSIDE of brew head
No brew
Spray disk plugged Clean spray disk
Damaged internal component or
wiring
Check switches, timer and solenoid. Repair,
replace as needed
Water supply OFF Turn water supply ON
Solenoid inlet strainer plugged Clean strainer
Water lter (if used) plugged Replace lter element
Poor coffee quality
Keep brewer and dispenser clean. Install a taste and odor lter in water supply, and
replace cartridges regularly. Use a quality fresh supply of tea leaves. Use amount of
tea leaves appropriate to brew volume.