User Manual

603 p/n 76451 8773_8774 Owmers Manual

7. Set the tank back into the brewer. Reassemble the tank lid to

the water tank. Make sure the gasket is properly in place,

then reinstall the hold-down strap.

8. Reinstall wiring to heating element and thermostat. Reinstall

the hi-limit thermostat (if removed). For automatic brewers,

reassemble piping for the faucet. Verify that all internal

components are dry, then reinstall the top panel.

9. Reconnect brewer to electrical supply and, for automatic

brewers, reconnect water supply.

10. Install the brew chamber without lter paper or grounds.

Run at least three full brew cycles and discard all water

generated.

11. Brewer is ready to use.

NOTE: Normally, silicone hoses

do not need to be delimed.

Should deliming hoses become

necessary, Bloomeld

recommends replacing the

hoses.

SERVICING INSTRUCTIONS (continued)