User Manual

TROUBLESHOOTING SUGGESTIONS

2M-Z16993-631 ECO Style Brewers

SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY

Water won’t heat

Brewer unplugged or circuit breaker

tripped

Check power supply cord

Check / reset circuit breaker

Hi-Limit thermostat tripped

Allow to cool

Reset hi-limit

Perform Deliming Procedures

Damaged internal component or wiring

Examine wiring & connectors, thermostat and

heating element, Repair/replace as needed

Pourover - no water or too little water

added at startup

Be sure to add sufcient water

Coffee level low (pour-over)

Not enough water poured in Increase water amount

Too much coffee grounds Adjust amount of grounds

Brew chamber overows

Too many lter papers or wrong lter

paper

Use one (1) genuine Bloomeld lter per brew

Brew chamber dispense hole plugged Thoroughly clean brew chamber

Too much coffee or too ne a grind Adjust coffee amount and grind

Too much water poured in Do not use more than 9 cups of water

Sprays water from brew

head

Spray gasket improperly installed Check/reinstall gasket on INSIDE of brew head

Spray disk plugged Clean spray disk

Poor coffee quality

Keep brewer, and decanters clean. Install a taste and odor lter in water supply, and replace

cartridges regularly. Use a quality coffee with a consistent roast. Use proper grind and

amount of coffee per brew.