User Manual

6
603 p/n 76451 8773_8774 Owmers Manual
OPERATION
Fig. 3 Model 8773 Operation Diagram
A. START-UP
For initial start-up, or if the brewer has not been used for an
extended period of time:
Be sure spray disk and brew gasket are properly installed in the
brew head.
For automatic brewers, be sure the water supply is properly
connected and the water supply valve is turned ON.
BEFORE plugging the brewer into a receptacle, or otherwise
connecting brewer to electrical power THE WATER TANK MUST
BE FILLED. Place an empty container under the brew head. Lift
the pour-over cover then pour three decanters of warm tap water
into the pour-over opening. Water will begin to ow from the brew
head. When all water ow stops, empty the container.
Once the tank is full of water, connect the brewer to electrical
power. Press the tank heater switch to ON. The heating elements
will begin heating the water in the tank. When the water has
reached the proper temperature, the “READY TO BREW” light will
glow.
IMPORTANT:
Tank must be full of
water before connecting
brewer to electrical power.
Heating elements will be
damaged if allowed to
operate without being fully
submerged in water.
Damage caused by
operating the brewer
without water in the tank
is NOT COVERED BY
WARRANTY.
Fig. 4 Fill the Tank
IL1627
IL1618