User Manual

ManualsBrandsBloomfield ManualsCommercial Beverage Equipment and Systems4A-1080TF-120C Automatic Thermal Coffee Brewer With Touch Keypad With Switches, Lights, Audible Signal, Built-In PourOver Mode, Energy-Saving Mode, Used For Canada Only, In Silver

642 p/n 2M-75872 1080 1082 1086 1088 Owmers Manual

OPERATION (continued)

ELECTRONIC FEATURES

Energizing the Brewer

When electric power is applied to the unit, all the lights will ash four

times and four beeps will sound. The unit will be off.

Press the ON/OFF key. Four beeps will sound and all lights will ash

once. The POWER indicator will remain on. If the water temperature

is more than 10ºF below the setpoint, the HEAT indicator will glow until

water temperature reaches setpoint.

Press the ON/OFF key again to turn the brewer off. Three beeps will

sound, the tank heater and all warmers will be switched off, and all

indicator lights will go out.

Brew Settings

See pages 15 & 16 for setting Brew Time and Temperature.

ABS™ (Automatic Brew Start)

Start a brew by pressing BREW. A single beep will sound. The system

will verify that the water in the tank is at the proper temperature. If it is,

brew will start immediately. Otherwise, the BREW indicator will ash

(Brew Waiting Mode) until the water reaches setpoint temperature,

then the indicator will glow and brew will commence. If the main

warmer is off, it will be energized automatically.

At the conclusion of the brew cycle, three beeps will sound.

NOTE: To override Brew Waiting Mode, press and hold the BREW key

for 3 seconds while the BREW indicator is ashing. Brew will begin

regardless of water temperature. To avoid under-temperature brews,

this feature should only be used when setting brew volumes.

NOTE: Brew Waiting Mode (BREW indicator ashing) prevents

multiple, unattended brews. While the BREW indicator is on or

ashing, any additional strokes of the BREW key will be ignored (there

will be a beep each time the key is pressed, however). Another brew

cannot be initiated until the previous brew is complete.

The Brew Waiting Time, also called Dripout Time, (interval between

when the brew is initiated and the audible signal sounds at the end

of the brew) may be adjusted between 2 and 8 minutes at the Brew

Signal Timer dial on the controller. See page 16.

Brew Cancel

To cancel a brew in progress or a brew in waiting, press the CANCEL

key. Two beeps will sound and the BREW indicator will go out.

NOTE: If a brew in progress is cancelled, coffee will continue to ow

until all water delivered has dripped through the brew chamber.

IMPORTANT:

DO NOT energize this

brewer until the water

tank has been lled. Dry

ring will damage heating

elements. See page 6.

Fig. 7 Turning Brewer

on or off

Fig. 8 Initiate a Brew

Fig 9 Brew Cancel