User Manual

8
OPERATION (continued)
ELECTRONIC FEATURES
Energizing the Brewer
When electric power is applied to the unit, the unit will beep four times
and the “HEAT” & “POWER” lights will come on. The unit will be on.
If the water temperature is more than 10ºF below the setpoint, the
HEAT indicator will glow until water temperature reaches setpoint.
Press the ON/OFF key again to turn the brewer off. Three beeps will
sound, the tank heater and all warmers will be switched off, and all
indicator lights will go out.
Brew Settings
See pages 17 & 18 for setting Brew Time and Temperature.
ABS™ (Automatic Brew Start)
Start a brew by pressing BREW. A single beep will sound. The system
will verify that the water in the tank is at the proper temperature. If it is,
brew will start immediately. Otherwise, the BREW indicator will ash
(Brew Waiting Mode) until the water reaches setpoint temperature,
then the indicator will glow and brew will commence. If the main
warmer is off, it will be energized automatically.
At the conclusion of the brew cycle, three beeps will sound.
NOTE: To override Brew Waiting Mode, press and hold the BREW key
for 3 seconds while the BREW indicator is ashing. Brew will begin
regardless of water temperature. To avoid under-temperature brews,
this feature should only be used when setting brew volumes.
NOTE: Brew Waiting Mode (BREW indicator ashing) prevents
multiple, unattended brews. While the BREW indicator is on or
ashing, any additional strokes of the BREW key will be ignored (there
will be a beep each time the key is pressed, however). Another brew
cannot be initiated until the previous brew is complete.
The Brew Waiting Time, also called Dripout Time, (interval between
when the brew is initiated and the audible signal sounds at the end
of the brew) may be adjusted between 2 and 8 minutes at the Brew
Signal Timer dial on the controller. See page 18.
Brew Cancel
To cancel a brew in progress or a brew in waiting, press the CANCEL
key. Two beeps will sound and the BREW indicator will go out.
NOTE: If a brew in progress is cancelled, coffee will continue to ow
until all water delivered has dripped through the brew chamber.
IMPORTANT:
DO NOT energize this
brewer until the water
tank has been lled. Dry
ring will damage heating
elements. See page 6.
641 p/n 2M-75844 1012 1040 1072 Owmers Manual
Fig. 7 Turning Brewer
ON or OFF
Fig. 8 Initiate a Brew
Fig 9 Brew Cancel
IL2206