industries OWNERS MANUAL HOT WATER DISPENSER

SERVICING INSTRUCTIONS (continued)

IMPORTANT:

When replacing heating

element, also replace seal

gaskets.

NOTE: Any abrasion or

roughness on the flat end of the

seat cup will require replacing

the seat cup:

REPLACE HEATING ELEMENT

Remove tank lid assembly as detailed on page 10.

Remove two hex nuts holding element to cover. Pull element

from mounting holes.

Reassemble in reverse order.

REPLACE SOLENOID

Unplug power cord. Turn OFF and disconnect water supply from

dispenser inlet fitting.

Remove rear panel. Remove two screws holding access door in

place. Remove access door and solenoid. Unscrew inlet fitting

cap to release solenoid from door. Remove wiring from solenoid.

Transfer fill tube from old solenoid to new solenoid.

Reassemble in reverse order.

REPAIR HOT WATER FAUCET

Unplug power cord. Turn OFF water. Unscrew bonnet from

faucet, then pull bonnet assembly from faucet body.

Examine the interior of the faucet body and the surface of the

seat cup. Clean out any debris in the faucet body, using a stiff

bristle brush if necessary.

If required, work the seat cup out of the bonnet and off of the end

of the stem. Install a new seat cup, making sure the knob on the

stem is fully inserted into the pocket of the seat cup, and the skirt

of the seat cup is fully inserted into the bonnet

Reassemble in reverse order.

712 76580 Owners Manual Hot Water Dispenser