Specifications

658 2M-Z17969 Owners Manual 2121 E-Max Satellite Brewer

INSTALLATION INSTRUCTIONS (continued)

IMPORTANT:

Initial set-up must be performed

by a qualied installer or

qualied service technician.

Improper set-up will damage the

brewer and void the warranty.

IMPORTANT:

Complete water line installation

before connecting brewer to

electrical power.

INITIAL SET-UP INSTRUCTIONS

Plumber’s and Electrician’s installation procedures must be

completed before proceeding with the set-up.

Be sure all electrical connections are secure, and that all

plumbing connections are secure and leak-proof.

1. CHECK BREWER FOR PROPER CONFIGURATION

Make sure spray disk gaskets are in place INSIDE of spray

heads.

Make sure spray disks are properly installed.

Check hot water faucet for proper operation and leaks.

Place empty satellites in position.

2. START BREWER OPERATION

When electricity has been connected to the unit, there will be

a momentary ash of the power light. Turn the brewer on by

pressing the POWER key.

The brewer will start to ll the tank. With the proper water

supply the tank should be lled in about 2½ minutes. Once

lled, the heating element will come on until the proper tank

temperature has been reached, (which will take about 20

minutes on 120-Volt models or about 12 minutes on 120/240

Volt models).

3. FINAL CHECKS

After initial heat-up and before brewing, draw water from the

hot water faucet until the inlet solenoid actuates. This will

prevent volume differences to the initial brew caused by

water expansion.

Press SATELLITE WARMER switch on. Brewer will not

operate unless the appropriate SATELLITE WARMER

switch on.