Specifications

643 2M-Z17088 Owners Manual 1883 E.B.C. Lo-Prole Airpot Brewer, 643 2M-Z17088 Owners Manual 1883 E.B.C. Lo-Prole Airpot Brewer,
643 2M-Z17088 Owners Manual 1883 E.B.C. Lo-Prole Airpot Brewer, 643 2M-Z17088 Owners Manual 1883 E.B.C. Lo-Prole Airpot Brewer,
SERVICING INSTRUCTIONS (continued)
IMPORTANT: Water pressure
must be between 20 p.s.i and

water pressure exceeds this
value, or if water pressure
varies greatly, a pressure
regulator must be installed in
the water supply line.
IMPORTANT: Before setting
assembly into tank, make sure
tank lid gasket is properly

IMPORTANT: When replac-
ing temperature probe, be sure
a new seal washer is in place
around the probe. Tighten jamb
lock nut only enough to ensure
no water leakage. Excessive
tightening is not necessary.
IMPORTANT: When replacing
heating element, also replace
seal gaskets.
SOLENOID TIME ADJUSTMENT
The amount of water dispensed automatically during a brew cycle

Place empty airpot under brew chamber. Press BREW button.
Brewer should dispense one full airpot of water. To adjust
amount:


cycles to check amount of water delivered. Replace button plug.


on the controller to account for the dripout time.
REMOVE TANK LID ASSEMBLY

supply. Remove top panel.


tank lid.
Disconnect all wiring from hi-limit and heating element.
Disconnect temperature probe from controller.

Remove cover assembly by lifting it straight up.
Reassemble in reverse order.
REPLACE TEMPERATURE PROBE
Unplug brewer. Remove top panel.

temperature probe. Disconnect temperature probe wiring
connector from controller.

Reassemble in reverse order.
REPLACE HEATING ELEMENT
Remove tank lid assembly per above.
Remove two hex nuts holding element to cover. Pull element
from mounting holes.
Reassemble in reverse order.
Fig. 10 Adjust Solenoid Time
WATER TEMP
( ºF )
OFF
185
190
195
200
205
10
20
30
40 50
60
80
SOLENOID TIMER
(WATER VOLUME)
(SECONDS)
BREW SIGNAL TIMER:
- BREW LIGHT
END OF BREW BEEPER
(MINUTES)
2
3
5
6
7
8
BREW TIME
DRIPOUT TIME
IL2687
