User's Manual

P a g i n a | 5
MANUAL | yooBee Badge Tracker yB-010040-BT
Before the device can be tracked, it has to be properly configured in the yooBee Cloud Console.
This can be done by means of the yooBee Toolbox app or directly in the Cloud Console (see
the yooBee Cloud Console User Manual).
Note: Switching off the operational mode is equivalent to putting the device in Transport
Mode.
3. Using the device
In operational mode, the tracker is active and connected to at least one and up to three yooBee
Hubs. It periodically broadcasts data from its inertial sensors, which is used in the Cloud
Console to track the position of the device.
If no movement was detected in the last 15 sec, the tracker goes into a sleep mode to preserve
battery life time. It is re-activated as soon as movement is detected.
In the background, the device runs protocols to establish and maintain connection with yooBee
Hubs in its proximity, and to roam between them.
4. Installation
The yooBee Badge tracker can be attached to a lanyard. Alternatively, the device can also be
glued to an asset, using double-side adhesive tape, preferably on a flat and smooth surface.