User`s manual

17
If your system is not ready, let a certi-
fied plumber make it ready.
1. Removing the transportation
safety bolts
Before the washing machine is oper-
ated, the transit bars must be re-
moved! In order to do this:
1. Loosen “C” bolts by rotating them
counter clockwise with a suitable
spanner
2. Remove transportation safety bolts
by turning.
3. Place “P” plastic covers onto the
openings of transportation locks by
rotating in direction of arrow and
pushing.
Attention please! Keep the transit
bars for using when machine is to be
transported again. Always transport
your machine with transportation
locks.
2. Leveling the feet
In order to operate your machine
without noise and vibration it must
be properly on balance. Four feet
of your machine can be adjusted.
First loosen the plastic counter bolt.
Tighten the counter bolt after adjust-
ing the feet for leveling your machine.
3. Water Connections
a) Water Inlet Hose
Your machine is connected to water
supply by special hoses supplied by
the machine. Red hose or hose writ-
ten red on it is hot water inlet, blue
hose or hose written blue on it is cold
water inlet.
There are plastic seals (4 for double
6
finished turn in clockwise direction
and close. Close the filter tap by
pushing.
Caution!
If the filter and hose tap does not fit, it
leaks water.
Installation