User Manual

38
USA
wait for evacuation of the steam inside for a while. Unload the dishes after
the pieces cool down to a touchable level. Start unloading process from the
lower basket. Thus, dropping of water remained on a piece at upper basket
onto the pieces at lower basket is prevented.
• Selected program is unsuitable. >>> Since rinsing temperature is low at
program with short duration, drying performance will also be low. Select
program with longer duration for a higher drying performance.
• Surface quality of the kitchen utensils is deteriorated. >>> Desired washing
performance can not be obtained at kitchen utensils with deteriorated
surfaces and it is not suitable to use such utensils in terms of hygiene
as well. Also, water can not flow easily on deteriorated surfaces. It is not
recommended to wash such kitchen utensils in dishwasher.
C
It is normal that drying complaints can be experienced with Teflon
kitchen utensils. It is associated with the structure of Teflon. Since the
surface tensions of Teflon and water are different, water droplets will
remain as beads on the Teflon surface.
Stains remaining on dishes when cycle has completed.
• Selected program is unsuitable. >>> Select a program with a higher
temperature and cycle time.
• Surface quality of the kitchen utensils is deteriorated. >>> Tea and coffee
stains or other dye spots may not be cleaned in dishwasher when they have
penetrated in deteriorated surfaces. Desired washing performance can not be
obtained at kitchen utensils with deteriorated surfaces and it is not suitable to
use such utensils in terms of hygiene as well. It is not recommended to wash
such kitchen utensils in dishwasher.
• Detergent is stored under unsuitable conditions. >>> If you are using powder
detergent, do not store the detergent package in humid places. Keep it in a
closed container if possible. For ease-of-storing, we recommend you to use
tablet detergents.
Lime traces remain on dishes and glassware gains a misty appearance
• Rinse aid is not sufficient. >>> Check the rinse aid indicator and add rinse aid
if necessary. Increase the rinse aid setting if there is enough amount of rinse
aid in the machine.
• Water hardness setting is low or salt level is insufficient >>> Measure the
hardness of the supply water appropriately and check the water hardness
setting.
• Salt leakage exists. >>> Pay attention not to spill salt around the salt filling
hole while adding salt. Make sure that the salt reservoir lid is tightly closed
after finishing the filling process. Run the prewash program to remove the salt
that spilled inside the machine. Since the salt granules that will remain under
the lid will dissolve during prewash, causing the lid loosen, check the lid once
again at the end of the program.