Installation

CONFIDENTIAL

 The ambient temperature must be between 55°F (13°C) and 110°F (43°C). Otherwise, function errors may

arise when the product is running.

 If it is not possible to avoid installing the product near a heat source, the minimum clearances given below

must be maintained between the product and the said source:

 11/4" (3 cm) from electric hobs or ovens

 12" (30 cm) from gas or fuel operated hobs or ovens

Please observe the following rules:

 The power socket or fuse must be easily accessible in case of an emergency; it must not be hidden behind

the product.

 Plug or cable must not touch the back surface of the product. Otherwise, it may get damaged due to the

vibration of the product.

 Do not connect the plugs of other appliances behind this product.

If the humidity level is high where the product is used, corrosion may be seen on the outer surface of the product.

Keep the installation room dry and well-cleaned to avoid corrosion.

To avoid the risk of electric shock:

 Connect the plug to a grounded 3-pin socket.

 Do not remove the ground terminal of the plug.

 Do not use adapters.

 Do not use extension cables.

ATTENTION:

Failure to follow these instructions may result in death, fire or electric shock. Connecting the grounding conductor of

the equipment to an improper place may lead to electric shock. Please have the grounding checked by a qualified

electrician or service technician if you have any doubt about the proper grounding of the product.

Installation, repair and other procedures performed by unqualified persons may cause danger. Before installing the

appliance, make sure that the voltage, load and circuit current parameters on the data plate are in compliance with

the power mains in your house.