User Manual Guide Sheet

15 / 90 ENOver The Range Microwave Oven / User Manual
OPERATION PROCEDURE5
This section includes useful information about
oven operation.
1. Plug power supply cord into a standard
3-pronged 15 Amp 120V AC 60Hz power outlet.
2. After placing the food in a suitable container,
open the oven door and put it on the glass
tray. The glass tray and roller guide must al-
ways be in place during cooking.
3. Close the door. Make sure that it is firmly
closed.
4. The oven light is on when the microwave
oven is operating.
5. The oven door can be opened at any time
during operation by pushing the door open
button of the control panel. The oven will au-
tomatically stop.
6. Each time a pad is pressed, a beep will sound
to acknowledge the press.
7. The oven automatically cooks on full power
unless set to a lower power level.
8. The display will show “ : 0” when the oven
CLOCK is not set.
9. Time clock returns to the present time when
the cooking time ends.
10. When the STOP/CLEAR pad is pressed
during oven operation, the oven stops cook-
ing and all information is retained. To erase all
information (except the present time), press
the STOP/CLEAR pad once more. If the oven
door is opened during oven operation, all in-
formation is retained.
11. If the START pad is pressed and the oven
does not operate, check the area between
the door and door seal for obstructions and
make sure the door is closed securely. The
oven will not start cooking until the door is
completely closed or the program has been
reset.
Make sure the oven is properly installed and
plugged into the electrical outlet.
To Set Power Level
The power level is set by pressing the POWER
LEVEL pad and number pad. If you wish to use a
different power level, press the POWER LEVEL
pad before pressing START pad. Enter the power
level desired by pressing the appropriate number
pad. The chart shows the display, the power level
and the percentage of power.
Press Power Level
Pad + Number
Power
Level
(Display)
Approx.%
of
Power
Power Level + 1 + 0 PL10 100%
Power Level + 9 PL-9 90%
Power Level + 8 PL-8 80%
Power Level + 7 PL-7 70%
Power Level + 6 PL-6 60%
Power Level + 5 PL-5 50%
Power Level + 4 PL-4 40%
Power Level + 3 PL-3 30%
Power Level + 2 PL-2 20%
Power Level + 1 PL-1 10%
Power Level + 0 PL-0 0%
NOTE: If “PL-0” is selected, the oven will work
with the fan but no power. You can use this level
to remove odors.
TINSEB594MRR0_BOTR30102SS_Blomberg OTR_User Manual.indd 15TINSEB594MRR0_BOTR30102SS_Blomberg OTR_User Manual.indd 15 10/5/20 11:51 AM10/5/20 11:51 AM